Smoke detector test

To perform the self-test, the smoke detector must be properly attached to the base plate.

• Briefly press and release the test button.
• The acoustic alarm, consisting of two cycles, each with three loud beeps, must sound and then stop automatically.
• The red indicator light on the smoke detector must flash rapidly during the playback of the acoustic signal.
• The red LED on the front of the smoke detector should now flash once every 40 seconds to indicate that it is activated.
• The smoke detector should be tested regularly (once a week is recommended).

Caution: The electronic test button checks the entire smoke detector. Therefore, do not attempt to test the detector with an open flame or fire.

How to avoid false alarms

• A smoke detector triggers an alarm when smoke or dust particles enter the smoke chamber at a certain concentration. This can also occur during renovation work if fine dust is generated by drilling, painting, or sanding and enters the measuring chamber. Therefore, when carrying out renovations, ensure that the smoke detector is removed or temporarily covered during this time.
• Painted smoke detectors lose their functionality.
• False alarms can also be triggered if smoke (e.g., from frying) or steam from the kitchen or bathroom enters other rooms equipped with smoke detectors. This can be avoided by, for example, keeping the kitchen door closed while cooking.
• Disabling the false alarm does not affect the functionality of the device. The smoke detector will then be fully functional again.
• Should an alarm be triggered, the smoke detector can be silenced using the "mute" button. It is important to ventilate your home thoroughly after pressing the mute button.

Minoprotect 1 fault messages

Signal sequence	Break	Signal sequence	Significance
• • •	1 sec.	• • •	ALARM Smoke alarm notification: LED flashes. In case of a false alarm, press the alarm stop button.
•	45 sec.	•	Low battery signal:The alarm beeps once approximately every 45 seconds, accompanied by a flashing LED. Contact customer service.
•	45 sec.	•	Fault indicator: The alarm beeps once approximately every 45 seconds, accompanied by a delayed flashing of the LED. Contact customer service.
•	1 sec.	•	Mute: This is acknowledged by the LED flashing. The LED flashes when muted, but there is no beep.

Important instructions

The installation locations for smoke detectors are legally regulated in the application standard DIN 14676. Smoke detectors must therefore not be removed from their original mounting location and installed elsewhere. Smoke detectors are designed to detect fires early through smoke development and warn you of the impending danger in time – especially at night when you are asleep and your sense of smell is inactive. Therefore, ensure that your smoke detector is functioning correctly – for your own safety. Painting over, wallpapering over, or covering the smoke detector will cause malfunctions or even device failure. Smoke detectors must not come into contact with aerosols or cleaning agents. Factors such as nicotine and insect residue can trigger false alarms. Smoke detectors cannot provide protection if, for example, someone is smoking in bed, children are playing with open flames, or in the event of explosions caused by escaping gas. Remove external dirt with a slightly damp cloth. The installation of smoke detectors can only be one component of a comprehensive fire protection concept. Smoke detectors are not a substitute for building insurance or other types of insurance.

Muting the Minoprotect 1

In the event of an unwanted alarm triggered by kitchen or water vapors, the smoke detector can be conveniently silenced for approximately 10 minutes using the alarm stop button. This can easily be done with a broom handle, for example. Silencing the alarm reduces its sensitivity. However, the smoke detector remains active. If muted due to a false alarm, the detector will reset after 10 minutes, restoring normal operation.